The parameters of stamping. More...

#include <sheet_metal_param.h>

Public Member Functions
	MbStampingValues ()
	Default constructor.

	MbStampingValues (const MbStampingValues &other)
	Copy-constructor.

	MbStampingValues (double h, double ang, double sketchRad, double baseRad, double bottomRad, bool inside, bool left, bool rev, bool op)
	Constructor by specific parameters.

MbStampingValues &	operator= (const MbStampingValues &other)
	Assignment operator.

void	Init (const MbStampingValues &other)
	Initialization by another object.

bool	IsSame (const MbStampingValues &other, double accuracy) const
	Determine whether an object is equal?

Public Attributes
double	hight
	Stamping height.

double	angle
	Slope angle of stamping sidewalls.

double	sketchFilletRadius
	Fillet radius of sketch (negative value prohibits fillet).

double	baseFilletRadius
	Fillet radius of base (negative value prohibits fillet).

double	bottomFilletRadius
	Fillet radius of bottom (negative value prohibits fillet).

bool	wallInside
	The sidewall is inside.

bool	leftFixed
	Geometry changes to the right of the sketch.

bool	reverse
	Direction of stamping construction.

bool	open
	Open stamping.

Detailed Description

The parameters of stamping.

Sketch of stamping sets the configuration of its bottom. Stamping is constructed by open or closed contour. Closed closed can lie entirely inside sheet face and can partially go out of its bounds. Both ends of open contour must lie outside of the stamped sheet face.
Depending on the parameter wallInside the stamping sidewalls are located inside or outside from sketch.
Height of stamping - is distance from plane of sheet to corresponding extruded part of stamping.
The angle parameter - is the angle of sidewalls deviation of stamping from the vertical in radians.
The leftFixed parameter indicates the side of the sketch which will be stamped and "reverse" - the direction of stamping along the normal to the planar face or along opposite to the normal.
If stamping is open, then sheet makes its way through and through.

The documentation for this struct was generated from the following file:

sheet_metal_param.h

Public Member Functions

Public Attributes

Detailed Description